7
6
Settings
BEFORE YOU START
1.When the monitor is OFF, press
and hold “User 1” button to enter
year setting.
Please proceed to time setting before your initial use so as to ensure
each piece of record is labeled with a time stamp. (Default Value: Date:
2012-01-01; Time: 00:00; Measurement Unit: mm Hg)
NOTE: The monitor will shut off automatically in 60 seconds after last
operation when in Setting Interface.
2.Press “Query” button to change
the numeral. Each press will
increase the numeral by one in a
cycling manner.
3.Press “User 1” button to confirm
the [YEAR]. Then the monitor
diverts to [MONTH] and [DAY]
setting automatically.
4.Repeat step 2 and 3 to confirm [MONTH] and [DAY]. Then the
monitor diverts to [HOUR] and [MINUTE] setting automatically.
BEFORE YOU START
MONTH
DAY
5.Repeat step 2 and 3 to confirm [HOUR] and [MINUTE]. Then the
monitor diverts to [UNIT] setting automatically.
HOUR
MINUTE
6.Repeat step 2 and 3 to confirm [UNIT].
7.After confirming the measurement unit, the LCD will display “dOnE”
and the monitor will shut off automatically.
To Next Page
Loading...
Need help?
General
