Congratulations!
You have acquired a quality product that has been developed using
TRAPP's spearhead technology. With this cost-effective and safe product, you
can do your work quickly and safely. For this, you must observe some extremely
important safety measures in this Instruction Manual. It is not possible to predict all
the situations that might occur. It is up to the operator to understand that common
sense, attention and careful operation cannot be added to the product - those who
use and maintain the equipment are responsible for these factors.
Important Recommendations
Attention!
Read all the instructions in this manual before
operating the equipment. Always observe
and follow the safety indications to prevent
accidents and/or injuries.
Read and keep these instructions
1 - Work area
Check the area where you will use the
equipment. Remove stones, wood debris,
wire, bones, glass and other unwanted
objects that could be flung by the equipment
and hurt badly both animals and people.
Do not use the equipment near
explosive-prone atmosphere nor where
there are flammable liquids, gases or
suspended dust. The motor produces sparks
that could ignite the flammable liquid, gases
or suspended dust.
Keep children and bystanders away.
When the equipment is being used, everyone
must stay away - especially children - at a
safe distance of at least 20 meters far from the
operator. The operator/user is responsible for
avoiding accidents.
Think how you will move to do the
cutting. Before you turn on the equipment,
simulate the movements. The right way to do
it from the right to the left.
2 - Power safety
Use the right extension cord. Always use
the right extension cord, which must be in
good shape, i.e. cannot be mended - never
use insulating tape to make repairs - you will
reduce the risk of electric shocks.
Do not move the equipment by the cord.
Never use the extension cord to carry, pull
or unplug the equipment from the power
source. Keep the extension protected from
heat, oil, sharp edges and especially from the
equipment's own blade.
This equipment runs with a universal-
type motor and comes with a thermal
protector. This protection could activate
while you are using the equipment if it
overloads. If this happens, do the following:
O Turn off the on/off key and remove the cord
from the power source and wait for approx.
25 minutes before you turn it on again.
O If the equipment turns off again automatically
call a TRAPP assistance service.
If you need maintenance and spare parts, get in
touch with you local distributor or an authorized
technical assistant:
In case of further difficulties, get in touch with:
METALÚRGICA TRAPP LTDA.
Av. Pref. Waldemar Grubba, 4545 - Cx.P. 106
89256-502 Jaraguá do Sul - SC - Brasil
Phone: +55 47 3371-0088 / +55 47 2107-8800
Fax: +55 47 3371-1997
e-mail: trapp@trapp.com.br
To Next Page
Loading...
