15
Fusion Spa minipool
EN
U
OPERATING MODES
ACTIVE MODE
In ACTIVE mode, the minipool is maintained in a condition that is readily usable by the user.
In this state, if there are no alarms all the functions are operational and the recirculation pump is always active to
lter the water.
When switched on, the control panel is set to the same state that it was in before it was turned off.
SLEEP MODE
SLEEP mode is used when the minipool is expected to remain unused for some time.
The water is therefore kept at a temperature (which can be set by the user) that is lower than that of normal use
(the default value is 25°C, the minimum temperature that can be set is 13°C).
STANDBY mode is maintained even in the even of blackouts and power surges.
In this state, the functions are deactivated and the recirculation pump - if no water level alarms are active - is
activated to maintain the temperature or to lter the water.
When the minipool is in STANDBY mode:
• The display shows the message "SBY".
• The heater starts working to maintain the temperature set (default value is 25°C).
• Filtering is in operation.
• For ltering with sanitising both the pump and the ozonator are activated twice a day (every 12 hours).
By default, the maintenance temperature
during standby is 25°C. To change it (down to a minimum of 13°C):
press the or keys
press the keys
PASSING FROM SLEEP MODE TO ACTIVE MODE AND VICE VERSA
simultaneously press the and keys
press the key
To Next Page
Loading...
