treesse FUSION SPA - Page 16

16
Fusion Spa minipool
EN
Use
BASIC FUNCTIONS
POWER ON
The minipool is powered on by connecting it to the mains.
At power-on all the LEDs/keys light up for three seconds, then
the version (Fxx, e.g., F01) and rmware revision (ryy, e.g.,
r05) are displayed.
FILLING
The bathtub is lled by pressing:
simultaneously the and
keys
lling in progress is indicated by the
LED
the key
lling in progress is indicated by the xed
blue key
Filling takes place from the bottom of the bathtub, and once
it has nished the tank is lled.
After reaching the correct level, the system automatically
stops the lling and makes available the functions of whirlpool,
recirculation, ozone and heater.
Once filling has been completed and all the conditions
necessary for the operation of the minipool are met, the system
automatically stops the function and makes the functions of
whirlpool, recirculation*, ozone*, heater** available.
* automatic functions that cannot be activated/deactivated by the user
** automatically manages the water temperature
During minipool use the system automatically maintains the
water level equal to the edge of the bathtub.
EMPTYING
hidden key
To avoid accidental emptying of the bathtub, a combination
of two keys is required to perform this operation: The bathtub
is emptied by pressing:
simultaneously the and
keys
emptying in progress is indicated by the
LED
of the hidden key for three seconds
(located below the display, even if it is
not visible it is still active), then press the
key
emptying in progress is indicated by the ashing
blue key
The emptying of the minipool can be activated at any time.
Emptying lasts about 120 minutes and for the entire duration
the bathtub needs to be powered to allow it to completely drain
all residual water from the tank, pipes and lter. To stop the
emptying test, disconnect the power supply to the bathtub for
about 30 seconds.
During emptying of the minipool, the only enabled function is
chromatherapy.