D: After being connected to power supply. The red light indicator on the top left of the
screen flashes once and then the cam will turn on. The blue light indicator will keep
on during your use. This can help you judge whether the cam is power supplied
normally.
2. Keeps turning on and off.
Solution:
A. Reset the camera to default setting. Under the stop status of recording mode,
press right button twice to enter setting menu. Then press down button to select
“Default setting” then choose “OK”.
B. Back up the SD card data first, then format the sd card in dash cam. Move toggle
switch to right direction to entry setting option---->Select "Format"---->Choose "OK".
C. Set Gsensor sensitivity to Medium level. And turn off parking monitor.
Under the stop status of recording mode, press right button to enter video setting
menu, then press down button to choose Gsensor, then select sensor sensitivity
”Medium”
3. The cam freezes & Screen goes black & Buttons do not work.
Solution:
A: Check whether your card is class 10, 8-64GB, SDHC TF card.
B: Long press the power button to force the shutdown to restart.
C: Press Reset button to reset the cam.
4. Unable to access menu settings (No response by pressing
menu button).
Solution:
The cam will stay in video mode after being turned on and will start recording
automatically if you have inserted a SD card. Press OK button to stop recording first.
Then press right direction button to enter settings.
5. The screen goes blue and prompts mass storage.
Solution:
When you connect the cam to computer or power source with low voltage, it is
normal that the cam prompts mass storage. You should use the USB cable in the
package to connect the cam to power supply with normal voltage.
11
To Next Page
Loading...