TREND CRT MK2 - OPTIONAL ACCESSORIES; Hose and Connector - CRT;3 & CRT;4; Large capacity extraction hose - T30;22

-15-
CRT MK2
OPTIONAL ACCESSORIES
Hose and Connector - CRT/3 & CRT/4
The back fence is provided with an extraction
point for connection to suitable vacuum
extractors. The internal hole diameter is 58mm
(2 1/4"). Suitable fittings with 58mm outside
diameter are available for most extractor units.
■ Only a vacuum extractor unit recommended
for use in the workshop should be used.
■ A suitable adaptor and extraction hose can
be purchased as optional accessories.
The hose (Ref. CRT/4) has an outside diameter
of 39mm and inside diameter of 32mm. The
hose adaptor (Ref. CRT/3) is a three piece
design that allows the hose to swivel freely.
■ Assemble the hose adaptor onto the end of
the hose as shown and insert into back
fence.
■ Fit the other end of the extraction hose to
your dust extractor.
39mm
x 3metre
Large capacity extraction hose - T30/22
A larger 58mm diameter hose 1.5 metres long
with integral connector is available (Ref. T30/22)
for fitting to the CRT and the Trend T30A vacuum
extractor. This hose will provide an increased rate
of air flow to improve extraction effectiveness.
■ The hose is simply inserted into the back fence
extraction point.
58mm x 1.5metre
T30/22
CRT/3
CRT/4