Need help?Do you have a question about the TREND KWJ700 and is the answer not in the manual?
General| Auto-Off | Yes |
|---|---|
| Tare Function | Yes |
| Display | LCD |
| Type | Kitchen Scale |
| Maximum Capacity | 7 kg |
| Readability | 1 g |
| Material | Plastic |
Disconnect from power supply when not in use, before servicing, or making adjustments.
Understand instructions supplied with power tool, attachment, and cutter.
Wear PPE for eye, ear, and respiratory protection. Keep clear of cutter.
Check cutter is sharp and undamaged before each use.
Details recommended cut depths and clearance for router operations.
Illustrates correct depths for bolt recesses in worktops.
Details for roughing and finishing cuts, including setup and diagrams.
Explains how to identify and use location pins for template alignment.
Procedure for setting up and cutting 90° right hand joints.
Procedure for setting up and cutting 90° left hand joints.
Procedure for setting up and cutting 45° corner joints.
Steps for setting up and cutting 45° male joints, including roughing and finishing cuts.
Steps for setting up and cutting 45° female joints, including roughing and finishing cuts.
Instructions for using the jig to square cut worktops.
Procedure for cutting peninsular joints, including template positioning and depth.
Guide for performing a 45° angle end cut on worktops.
Instructions for cutting corner radii R40mm or R100mm.
Coating cut edges with adhesive or sealant for moisture protection.
List of recommended router cutters for use with the jig.
Information on the UNIBASE sub-base set for accurate joints.
Details on the 30mm guide bush (Ref. GB30/A) for precise cuts.
Guidelines for maintaining and cleaning the jig for optimal performance.
Solutions for joints not fitting correctly or having incorrect radius.
Addressing issues with joint alignment and irregular gaps.
Remedies for chipped laminate and jig slipping on material.
Ensuring square joints and flush assembly, and checking worktop thickness.
To Next Page
