-5-
ITEMS ENCLOSED
1 x Parallel side-fence with rods
1 x Collet 6mm
1 x Collet 6.35mm (
1
/4”) fitted to machine
1 x Collet 8mm
1 x Guide bush 16mm and fixing screws
1 x Spanner (17mm A/F) for collet nut
1 x Spanner (14mm A/F) for spindle (in carving
mode)
1 x Hex key (4mm A/F) for side-fence
1 x Dust extractor spout
1 x Instructions
1 x Guarantee card
LABEL
The label on your tool may include the following
symbols.
V ................................................volts
Hz ..............................................hertz
min..............................................minutes
..............................................Class II
Construction
A ................................................amperes
W ................................................watts
..............................................alternating
current
n
o................................................no load speed
.../min..........................................revolutions or
reciprocations
per minute
T4
MANUFACTURERS
DECLARATION
We declare under our sole responsibility that
this product is in conformity with the
following standards of standardised
documents:
EN 60745, EN 55014, EN 61000, in
accordance with the directives 98/37/EC,
73/23/EEC, 89/336/EEC.
Level of sound pressure according to
86/188/EEC & 98/37/EC, measured
according to EN 60745:
Lpa (sound pressure) 91.1 dB(A) 1
Lwa (acoustic power) 104.1 dB(A) 2
Radio and TV suppression in compliance
with 76/889/EEC and 82/499/EEC
INFORMATION ON
NOISE/VIBRATION
The noise level when working
can exceed 85 dB(A).
Wear ear protection!
Weighted root mean square
acceleration value according to EN 60745:
3.0 m/s
2
(hand arm method)
Trend Machinery & Cutting Tools Ltd.
Managing Director
Jeff Willcocks
T4E
MANU/T4 v2.0 30/8/07 1:08 pm Page 5
To Next Page
Loading...
