Need help?Do you have a question about the TRENDnet TEG-S50ES and is the answer not in the manual?
Details the steps to assign a static IP address to the switch and access its web management interface.
Explains how to log into the switch's web management interface using a web browser.
Details how to change the switch's IP address, subnet mask, and default gateway settings.
Explains the procedure to change the default administrator password for enhanced security.
Configures port parameters like speed, duplex, flow control, and jumbo frames.
Sets up Spanning Tree Protocol (STP) state and mode for network topology management.
Manages storm control and rate limiting for broadcast, multicast, and unicast traffic.
Covers adding, modifying, and removing VLANs, and configuring port settings.
Details the process of upgrading the switch's firmware to add features or fix issues.
Explains how to back up and restore the switch's configuration settings.
Details support for Spanning Tree, Link Aggregation, QoS, VLAN, Multicast, Port Mirror, and Storm Control.
Provides steps to resolve issues when the switch management page cannot be displayed.
Explains how to handle situations where the switch IP differs from the network subnet.
Details the steps to assign a static IP address to the switch and access its web management interface.
Explains how to log into the switch's web management interface using a web browser.
Details how to change the switch's IP address, subnet mask, and default gateway settings.
Explains the procedure to change the default administrator password for enhanced security.
Configures port parameters like speed, duplex, flow control, and jumbo frames.
Sets up Spanning Tree Protocol (STP) state and mode for network topology management.
Manages storm control and rate limiting for broadcast, multicast, and unicast traffic.
Covers adding, modifying, and removing VLANs, and configuring port settings.
Details the process of upgrading the switch's firmware to add features or fix issues.
Explains how to back up and restore the switch's configuration settings.
Details support for Spanning Tree, Link Aggregation, QoS, VLAN, Multicast, Port Mirror, and Storm Control.
Provides steps to resolve issues when the switch management page cannot be displayed.
Explains how to handle situations where the switch IP differs from the network subnet.
General| Power connector | DC-in jack |
|---|---|
| Installed SFP modules quantity | - |
| Basic switching RJ-45 Ethernet ports type | Gigabit Ethernet (10/100/1000) |
| Basic switching RJ-45 Ethernet ports quantity | 5 |
| Switch type | Managed |
| Quality of Service (QoS) support | Yes |
| 10G support | No |
| Networking standards | IEEE 802.11d, IEEE 802.1Q, IEEE 802.1p, IEEE 802.1w, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x |
| Virtual LAN features | Private VLAN, Voice VLAN, Tagged VLAN, Port-based VLAN |
| Security algorithms | SNMP, SNMPv3 |
| Queue scheduling algorithms | SP, WFQ |
| Jumbo frames | 9000 |
| Forwarding rate | 7.44 Mpps |
| MAC address table | 2000 entries |
| Certification | CE, FCC |
| Product color | Black |
| Housing material | Metal |
| Mean time between failures (MTBF) | 1633047 h |
| Input current | 0.2 A |
| Output current | 1 A |
| Output voltage | 5 V |
| AC input voltage | 100 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 3.42 W |
| Operating temperature (T-T) | 0 - 40 °C |
| Operating relative humidity (H-H) | 0 - 90 % |
| Harmonized System (HS) code | 85176990 |
Weight and Dimensions| Depth | 82 mm |
|---|---|
| Width | 100.5 mm |
| Height | 28 mm |
| Weight | 224 g |
To Next Page
