Thank you for purchasing TRENDnet's TEW-453APB Hot Spot Wireless
Access Point.
This guide will help you set-up your Access Point quickly and easily. Just follow
the step-by-step instructions below, and enjoy the benefits of accessing the
Internet without ever being tied down to wires! If you run into problems, please
refer to the Troubleshooting section. If you need further technical support,
please visit www.TRENDNET.com or call technical support by phone.
Verify Equipment
Before setting up the Access Point, you should have the following:
1. A computer with Wired (RJ45) or Wireless network card.
2. TCP/IP protocol installed on the Computer.
3. A web browser such as Internet Explorer (5.0 or higher) or Netscape
Navigator (4.7 or higher).
4. A Hub or Switch connecting your existing wired network.
5. An RJ-45 Network Cable for connecting the Access Point to your network
switch.
Verify Package Contents
Please make sure you have everything in the box:
1
Power Adapter
(24V DC, 500mA)
CD-ROM
Quick Installation Guide
TEW-453APB
1. Prepare for Installation
English QIG
English
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
TRENDnet
TRENDware, USA
What's Next in Networking
TEW-453APB
Version 03.02.2005
Hot Spot Wireless Access Point
Quick Installation Guide
Point d'accès sans fil sensible
Guide d'installation rapide
Drahtloser Access Point für Hotspots
Kurzanleitung zur Installation
Guía de instalación rápida del
punto de acceso inalámbrico Hot Spot
To Next Page
Loading...
Need help?
General
