Wireless
This section enables users to configuration the wireless communications parameters
for the WLAN Router.
Basic
This page allow user to enable and disable the wireless LAN function, create a
SSID, and select the channel for wireless communications.
Enable/Disable: Enables or disables wireless LAN via the WLAN Router.
SSID: Type an SSID in the text box. The SSID of any wireless device must match
the SSID typed here in order for the wireless device to access the LAN and WAN
via the WLAN Router.
Channel: Select a transmission channel for wireless communications. The channel
of any wireless device must match the channel selected here in order for the
wireless device to access the LAN and WAN via the WLAN Router.
802.11 Mode: Select one of the following:
z Mixed 802.11g and 802.11g - Select if you are using both 802.11b and
802.11n wireless clients.
z Mixed 802.11n, 802.11b, and 802.11g - Select if you are using a mix of
802.11n, 11g, and 11b wireless clients.
Channel Width: Select the Channel Width:
z Auto 20/40 - Select if you are using both 802.11n and non-802.11n wireless
devices.
z 20MHz - This is the default setting with single channel support required by
Wi-Fi regulations.
To Next Page
Loading...
Need help?
General
