Getting Started
For a typical wireless setup at home, please do the following:
1 Connect one end of the provided network cable into your computer’s network port, and connect the
other end of the provided network cable into the TEW-637AP’s Ethernet port.
2 Plug the power adapter to outlay, and connect the power jack to the TEW-637AP.
3 Verify that the Power & Ethernet LEDs are lit.
4 Insert Setup Wizard CD into your CD-ROM drive.
5 The Welcome screen appears on your monitor. Click Start button.
6 Read the License Agreement and click Next to continue the installation.
7 Your computer will detect TEW-637AP and the Device List screen appears on your monitor. Click
Configure button to continue (default TEW-637AP IP Address is 192.168.10.100).
8 Enter password for the Access Point. The default password is “admin”. Click Login button to
continue.
Page 9
To Next Page
