2
1. Bring the TEW-821DAP to a location of its final installation point.
3. If you are connecting your TEW-821DAP to a PoE switch, the device will power on
automatically. If you are connecting to a computer, or a non-PoE switch, you will need to use
the included power adapter.
4. To use the power adapter, plug the power adapter into the TEW-821DAP, then plug the
adapter into an electrical outlet. Wait 60 seconds, then confirm that the status LEDs on the
front of the unit are illuminated. Your TEW-821DAP access point is now active. The device is
pre-configured to automatically connect to your network.
2. Initial Access Point Setup
2. Connect the TEW-821DAP to your router or switch. You may also connect the device directly
to a network port on your computer. If you are connecting to a router or switch, make sure
your computer is connected to the same network.
5. For your security, each TEW-821DAP comes pre-encrypted with a unique WiFi Name (SSID)
and WiFi Password. You can find your device's SSID and WiFi password on the white labels
located on the device. Use this information to connect to the TEW-821DAP access point. If
the TEW-821DAP is reset, the SSID and WiFi key will also be reset to the default login
credentials located on the white label.
6. No further setup is required, proceed to Section 4 Mounting the Device. To change device
settings proceed to Section 3 AP Management Utility.
Preset
Wireless Settings
Wi-Fi Name/SSID
(AC/N)
TRENDnetXXX_5GHz_XXXX
(N/B/G)
TRENDnetXXX_2.4GHz_XXXX
Wi-Fi Password
Management Login
http://tew-821dap
username: admin
password: admin
XXXXXXXXXXXXX
To Next Page
Loading...
Need help?
General
