© Copyright 2017 TRENDnet. All Rights Reserved.
7. In the list below, click Create to create a new wireless profile.
8. In the Edit Wireless Group window, enter the wireless network name/SSID for the
wireless network. (e.g. TRENDnet-WiFi)
Note: The SSID is the wireless network name used to broadcast and be discovered by
your wireless client devices to connect to your wireless network.
9. For Roaming options, select 802.11k and OKC wireless roaming protocols to ensure
fast transition wireless connectivity for client devices when roaming between multiple
access points.
10. For Authentication method, select WPA/WPA2-PSK. For the Security Mode, select
WPA2-Personal. For the WPA Cipher, select AES and enter the Pre-Shared Key required
to connect to your wireless network. Click OK.
Note: The pre-shared key is the key/password (8-63 alphanumeric characters) client
devices will be required to enter in order to connect to your wireless network.
Note: It may take up to 1 minute for configuration settings to be applied to the access
points.
11. The initial wireless settings are complete.
Note: The access points must be connected to the same IP subnet as your wireless
controller. (e.g. 192.168.10.x / 255.255.255.0)
To Next Page
Loading...
Need help?
General
