CRYSTAL
26
- Time Information - Through the Time Information function you can display the operating time of the
projector.
- Temperature - Through the Temperature function can be displayed the temperature inside the fixture,
near the lamp. The temperature can be displayed in degrees Celsius or Fahrenheit.
- Fans Speed - Through the Fans Speed function you can show on display the fan speed present near the
lamp. Velocity is expressed in RPM (revolutions per minute).
- Channel Value - Channel Value function can be used to display the values of the channels by which the
unit will operate when switched on.
- Error Message - Through the Error Message function can be displayed any errors channels.
- Fixture Model - Through the Fixture Model function can be displayed the model number and manufac-
turer.
- Software Version - Through Software Version function you can display the currently installed software
version.
• Press the LEFT button repeatedly to exit the menu.
3.22 RESET FUNCTIONS
You can start a preset program to restore the selected function:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Set icon, then press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, select Reset and press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, then select the function you wish to reset be-
tween All, Pan&Tilt, Colors, Gobos and Others.
• Press the ENTER button to confirm your choice and wait for the recovery of the selected function.
3.23 SPECIAL FUNCTIONS
For the CRYSTAL you can access the following special functions:
No Signal
Select this feature to set the preferred mode of operation to be activated in case the drive is not present
no DMX signal input:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Set icon, then press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, select UI Set, and press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, then select No Signal and press ENTER to con-
firm.
• Press the UP/DOWN button to select the preferred mode of operation: Close/Hold/Auto/Music.
• Press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.
Fans Mode
Select this function to set the fans operation mode:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Set icon, then press the ENTER button to enter
the next menu.
To Next Page
Loading...