THE SHIPPING BANDS MAY BE UNDER TENSION. USE APPROPRIATE EYE,
FACE, AND HAND PROTECTION TO SAFEGUARD AGAINST INJURY FROM
BAND BACKLASH.
VERIFY THAT ALL INCOMING LINE VOLTAGE (POWER) AND LOW VOLTAGE
(CONTROL) CIRCUITS ARE DE-ENERGIZED AND LOCKED OUT BEFORE
INSTALLING CABLES OR MAKING CONNECTIONS, WHETHER IN THE
JUNCTION BOX OR IN THE UNIT.
EQUIPMENT INSPECTION AND START-UP SHOULD BE PERFORMED ONLY
BY TRAINED PERSONNEL. LETHAL VOLTAGES ARE PRESENT DURING
START-UP PROCEDURES. ELECTRICAL SAFETY PRECAUTIONS MUST BE
FOLLOWED THROUGHOUT INSPECTION AND START-UP.
ONLY QUALIFIED SERVICE PERSONNEL SHOULD PERFORM MAINTENANCE
ON THE RACK MOUNT POWER DISTRIBUTION UNIT SYSTEM. ALL VOLTAGE
SOURCES TO THE UNIT MUST BE DISCONNECTED BEFORE INSPECTING OR
CLEANING WITHIN THE CABINET.
LETHAL VOLTAGES EXIST WITHIN THE EQUIPMENT DURING OPERATION.
OBSERVE ALL WARNINGS AND CAUTIONS IN THIS MANUAL. FAILURE TO
COMPLY MAY RESULT IN SERIOUS INJURY OR DEATH. OBTAIN QUALIFIED
SERVICE FOR THIS EQUIPMENT AS INSTRUCTED.
All power and control wiring should be installed by licensed electricians and must comply
with the NEC and applicable codes.
To Next Page
Loading...