1.1.3 RPDU Preparation
The Rack Mount Power Distribution Unit may be easily removed from the shipping pallet and
set in place by customer personnel. A typical procedure is as follows:
1. Set the Package in a level area, where there is enough room to unpack the box.
2. Cut the shipping straps.
WARNING: THE STRAPS MAY BE UNDER TENSION. USE PROTECTIVE
EYE, FACE, AND HAND GEAR TO PREVENT INJURY FROM STRAP
BACKLASH.
3. Remove the straps and cardboard package.
4. Prepare the location on the rack.
5. Set the unit in place (Utilizing a lift) secure the unit on the rack with the provided
screws.
(Please see the next steps described in section 1.1.4)
To Next Page
Loading...