triopo Speedlite - High-speed Synchronous; High-Speed Sync and Rear-Curtain Sync; Multi-lamp Lighting Applications; Wireless Lighting Setup

21
22
“ ”High-speed synchronous
“ ”Rear-curtain sync settings
High-speed synchronous: can make flash with the camera high shutter
speed synchronous operation,in the use of flash photography outdoor
portraits and other strong light source Shall use a large aperture, this
model is very useful.
Rear-curtain sync:With a slow shutter speed,you can create a light trail
following the subject, the flash fires right before the shutter closes.
1.Canon version speedlite,Under E-TTL,M mode,If you want to
correct use the High-speed sync/Rear-curtain sync funtion,Press
the 【High-speed sync/Rear-curtain sync/Ordinary flashlight】
switch key to ordinary flash (no, display)→High-speed
synchronization( )→Rear-curtain sync ( ) to open the
corresponding function.
2.Nikon version speedlite,you can't directly set automatic high-speed
synchronous mode on the speedlite,First setting the Camera Menu to
'FP' automatically open,When connect the camera the flash screen
display 'FP' immediately. If you need the Rear-certain synchronous
mode,The same settings to open the Rear-curtain sync on the camera
Menu.(There is no display on the speedlite)
Note:To correct use the High-speed sync/Rear-curtain sync,please
properly set camera flash mode and shutter speed.
Multi-lamp lighting applications
1.Wireless lighting light instructions
Multi stage flash, wireless flash configuration
You can create two or three slave groups to complete the multi-
directionalshooting demand. And a main controlling flash setting TTL
auto flash shooting flash ratio, manual flash output, stroboscopic etc.
(1) Using this speedlite make two slave groups Wireless flash
Set of wireless options: there are SLAVE c/SLAVE n options
A communication channel is provided: 1, 2, 3, 4
Set group: two speedlite are set to A, B g r ou ps
Set the Master unit: a communication channel is provided: set the flash
ratio of Master unit A:B or A:B:C, to flash shooting
(2) The speedlite make three slave groups Wireless flash
Set of wireless options: there are SLAVE c/SLAVE n options
A communication channel is provided: 1, 2, 3, 4
Set group: three speedlite are divided into A, B, C groups
A main control unit and shooting: a communication channel is provided:
the main control unit of the flash ratio is <A:B:C>.
Pressed to the Master unit to test flash ,test the flash normal or no.
If the slave unit does not flash, please check the speedlite toward the
master unit angle and distance to the master unit
Note: the Master unit if you set the <RATIO A:B>, set as a slave unit
<C> group will not flash .If the group of three speedlite is set to <A>,
then they will be used as a flashlight acceptor slave control by groups
control unit.
This speedlite can receive signals from the Master High-speed
synchronous flash (i.e., away from the machine high speed
synchronization)