14
4. If you are on the same network as the B051-000, the client will locate it and display
it in the Device List. In this case, highlight the unit in the device list and click the
Login button. If you are not on the same network as the unit, it will not be displayed
in the list. You must manually enter the IP address, as given to you by your system
administrator, in the IP Address eld, and then click the Login button.
5. Upon clicking the Login button, you will be prompted to enter in a Username and
Password. Enter your username and password as given to you by your system
administrator. If you are an administrator logging in for the rst time, the default
username is administrator, and the default password is password. The four buttons
on the right of the non-browser client main page will be activated, allowing you
to remotely access the connected computer/KVM switch (See Remote Session
Operation section in the Owner’s Manual for details) or the Admin Utility. (See Admin
Utility section in the Owner’s Manual for details.)
Logging Into the B051-000
Non-Browser Login continued
12-003 932851-EN.indd 14 8/7/2012 8:59:48 AM
To Next Page
Loading...
