Tripp Lite B126-2A1 - Page 11

B126-004
OPTIONAL LOCAL
MONITOR
BLU-RAY
B126-2A0B126-2A0
B126-2A0B126-2A0
Up to 200 ft. at 1080i @ 60Hz (Cat6)
Up to 150 ft. at 1080p @ 60Hz (Cat6)
HDMI OVER Cat5
1 x 2 EXTENDER
REMOTE UNIT
MODEL: B126-2A0
HDMI OVER Cat5
1 x 2 EXTENDER
REMOTE UNIT
MODEL: B126-2A0
HDMI OVER Cat5
1 x 2 EXTENDER
REMOTE UNIT
MODEL: B126-2A0
HDMI OVER Cat5
1 x 2 EXTENDER
REMOTE UNIT
MODEL: B126-2A0
11
Standard Extender/Splitter Installation
1
MakesurealldevicesbeingconnectedarepoweredOFF.
2
Connect the HDMI source to the INPUT port on a B126-002 or
B126-004transmitterunitusingaTrippLiteP568-SeriesHigh-Speed
HDMICable.
3
Optional for B126-004: Connect a monitor to the LOCAL port on the
transmitterunitusingaTrippLiteP568-SeriesHigh-SpeedHDMICable.
4
Connecttheexternalpowersupplytothetransmitterunitandplugthe
transmitterunitintoaTrippLiteSurgeSuppressor,PowerDistribution
Unit(PDU),orUninterruptiblePowerSupply(UPS).ThegreenRJ45
LEDsontheB126-002andB126-004,andtheredpowerLEDon
the B126-004 will illuminate to indicate that the unit is receiving
powerfromtheexternalpowersupply.
5
UsingCat5e/6cable,connectaRJ45OUTPUT port on the transmitter
unittotheRJ45INPUTportontheB126-2A01x2receiverunit.
6
Repeatstep5toaddreceiverunitstotheremainingRJ45OUTPUT
ports on the transmitter unit.
13-08-043 93-32D0.indd 11 8/28/2013 2:17:40 PM