Tripp Lite B126-2A1 User Manual

OPTIONAL LOCAL
MONITOR
B126-2A1 LOCAL
TRANSMITTER
B126-2A1 REMOTE
RECEIVER
B126-110 REMOTE
REPEATER
B126-110 REMOTE
REPEATER
B126-110 REMOTE
REPEATER
Up to 175 ft. at 1080i (60Hz)
Up to 125 ft. at 1080p (60Hz)
Up to 175 ft. at 1080i (60Hz)
Up to 125 ft. at 1080p (60Hz)
BLU-RAY
Up to 175 ft. at 1080i (60Hz)
Up to 125 ft. at 1080p (60Hz)
Up to 175 ft. at 1080i (60Hz)
Up to 125 ft. at 1080p (60Hz)
MONITOR 1 MONITOR 2
7
1 x 2 Extender Kit with
Remote/Repeater Installation
Notes:
1. Test to make sure that the entire installation works properly before
running cables through ceilings/walls.
2. The diagram below shows the maximum extension distance when using
either Cat5e or Cat6 cabling. 24 AWG, solid wire Cat5e/6 cable, such
as Tripp Lite’s N202-Series, is required to achieve maximum distance
and resolution.
3. The B126-2A1 is set to transmit a stereo audio signal by default.
Press the Audio button on the transmitter unit to switch to 7.1-channel
surround sound audio. (7.1-channel surround sound signal will be
Multi-Channel or PCM)
1
MakesurealldevicesbeingconnectedarepoweredOFF.
2
ConnecttheHDMIsourcetotheINPUT port on the transmitter unit
usingaTrippLiteP568-SeriesHigh-SpeedHDMICable.
3
Optional: Connect a monitor to the LOCAL port on the transmitter
unitusingaTrippLiteP568-SeriesHigh-SpeedHDMICable.
13-08-043 93-32D0.indd 7 8/28/2013 2:17:39 PM

Tripp Lite B126-2A1 Specifications

General

Brand	Tripp Lite
Model	B126-2A1
Category	Extender
Language	English