33
TRISAN S8 Printing test tags
Print test tags
Require a SATO BRAND CG2 or MB200i PRINTER.
CG2 must be defaulted to RS232 mode
Trisan printer interface cable.
Keyboard
To print test tags the data base and printer must be enabled in the utility menu.
The date shall be correct, if not, correct it via key board.
Set re-test period
While in the utility menu select ……. Set re-test period
Choose between the following:
Set default period
Prompt every test
No retest period
Use the F1 or F2 buttons to scroll up and down and press START for selection.
To select period choice as follows:
1 month press F1
3 months press F2
6 months press LEADS
1 year press OTHER APPLIANCE
2 years press EARTHED APPLIANCE
5 years press DOUBLE INSULATED
Must connect printer to tester via interface cable while powered off or damage may result.
Power up both items and system set for printing tags after every test.
A prompt will appear before printing: PRINT LABEL ?
Press START test tag should print.
Another message prompt will be displayed CHECK LABEL! REPRINT?
Do not press START or RESET until you are satisfied that tag is good and successfully applied to appliance.
If you damage the tag upon application to appliance, reprint another tag at this time.
Test tag information
Retest date: …………. This is printed twice at each end of tag.
Test date:……………. Taken from the in built clock, this must be right.
Tested by:…………… Technician name taken from data base field.
Asset/Appliance number:…. Ensure this is enabled in the utility menu or no number will print.
A Bar code defining the number will also print.
By regulation the name and type of the tag, the standard to which the test was conducted to:AS/NZS3760
with reference to safety representative maintaining records of tests conducted shall be sighted on tag.
Result: PASS/FAIL type of test conducted…………. additional information.
To Next Page
Loading...