Why does my Triumph Adler All in One Printer operation panel not respond?
If the operation panel of your Triumph Adler All in One Printer does not respond when the power switch is turned on, ensure that the power cord is plugged into an AC outlet.
Why does my Triumph Adler All in One Printer paper often jam?
If paper often jams in your Triumph Adler All in One Printer, several reasons could be the cause. Ensure the paper is loaded correctly. Check if the paper is of the supported type and in good condition; if not, remove it, turn it over, and reload it. Replace curled, folded, or wrinkled paper with new paper. Also, remove any loose scraps or jammed paper from the machine.
What to do if my Triumph Adler All in One Printer cannot print?
If your Triumph Adler All in One Printer cannot print, first ensure the machine is plugged into an AC outlet and turned on. Check that the printer cable is securely connected. If the machine was powered on before connecting the cable, power it on again after connecting the cable. If the print job is paused, press [Resume]. Finally, if an error message is displayed, follow the corresponding procedure.
What to do if my Triumph Adler All in One Printer printouts are too dark?
If your Triumph Adler All in One Printer's printouts are too dark, check the density settings. If the machine is in Auto Density mode, set the correct density level for auto density. If it's in Manual Density mode, select the correct density level.
What to do if my Triumph Adler All in One Printer ejects blank sheets?
If your Triumph Adler All in One Printer is ejecting blank sheets, check how the originals are loaded. When placing originals on the platen, ensure they are face-down and aligned with the slit glass. When using the document processor, place the originals face-up.
What to do if my Triumph Adler All in One Printer cannot send via SMB?
If your Triumph Adler All in One Printer cannot send via SMB, ensure the network cable is securely connected. Verify that the network settings for the equipment have been configured properly, including TCP/IP settings, folder sharing settings, and access privileges. Confirm that the SMB protocol is set to [On]. Check that the [Host Name], [Path], [Login User Name], and [Login Password] have been entered correctly. Ensure the same domain name hasn't been used for both [Host Name] and [Login User Name]. Configure exceptions for Windows Firewall properly. Finally, ensure the time settings for the equipment, domain server, and data destination computer are the same.
What to do if the top edge or back of the paper is dirty after printing with my Triumph Adler All in One Printer?
If the top edge or back of the paper is dirty after printing with your Triumph Adler All in One Printer, the inside of the machine may be dirty. Clean the inside of the machine.
What does it mean when my Triumph Adler All in One Printer says 'Load paper in cassette 1'?
If your Triumph Adler All in One Printer displays 'Load paper in cassette 1', it means the indicated cassette is out of paper. Load paper into the cassette.
What to do if my Triumph Adler All in One Printer cannot print with USB memory?
If your Triumph Adler All in One Printer cannot print with USB memory, check if the USB host is blocked. If it is, select Unblock in the USB host settings.
Why are my Triumph Adler All in One Printer printouts wrinkled or curled?
If your Triumph Adler All in One Printer's printouts are wrinkled or curled, the paper might be damp. Replace the paper with new paper.
General| Brand | Triumph Adler |
|---|---|
| Model | DC 6130 |
| Category | All in One Printer |
| Language | English |
To Next Page
