Storage
162
STORAGE
Preparation for Storage
Clean and dry the entire vehicle
thoroughly.
Fill the fuel tank with the correct grade
of unleaded fuel and add a fuel
stabiliser (if available), following the fuel
stabiliser manufacturer's instructions.
Warning
Petrol is extremely flammable and can
be explosive under certain conditions.
Turn the ignition switch off. Do not
smoke. Make sure the area is well
ventilated and free from any source of
flame or sparks; this includes any
appliance with a pilot light.
Remove the spark plug from each
cylinder and put several drops (5 cc) of
engine oil into each cylinder. Cover the
spark plug holes with a piece of cloth or
rag. With the engine stop switch in the
RUN position, push the starter button
for a few seconds to coat the cylinder
walls with oil. Install the spark plugs,
tightening to 12 Nm.
Change the engine oil and filter (see
page 117
).
Check and if necessary correct the tyre
pressures (see
page 164
).
Set the motorcycle on a stand so that
both wheels are raised off the ground.
(If this cannot be done, put boards
under the front and rear wheels to keep
dampness away from the tyres.)
Spray rust inhibiting oil (there are a host
of products on the market and your
dealer will be able to offer you local
advice) on all unpainted metal surfaces
to prevent rusting. Prevent oil from
getting on rubber parts, brake discs or
in the brake calipers.
Lubricate and if necessary adjust the
drive chain (see
page 124
).
Make sure the cooling system is filled
with a 50% mixture of coolant (noting
that HD4X Hybrid OAT coolant, as
supplied by Triumph, is pre-mixed and
requires no dilution) and distilled water
solution (see
page 120
).
Remove the battery, and store it where
it will not be exposed to direct sunlight,
moisture, or freezing temperatures.
During storage it should be given a slow
charge (one Ampere or less) about once
every two weeks (see
page 147
).
Store the motorcycle in a cool, dry area,
away from sunlight, and with a minimum
daily temperature variation.
Put a suitable porous cover over the
motorcycle to keep dust and dirt from
collecting on it. Avoid using plastic or
similar non-breathable, coated materials
that restrict air flow and allow heat and
moisture to accumulate.
To Next Page
Loading...
Need help?
General
