Triumph Tiger XR User Manual

General Information
81
Seats
Seat Care
To prevent damage to the seat or seat
cover, care must be taken not to drop or
lean the seat against any surface which
may damage the seat or seat cover.
See
page 157
for seat cleaning
information.
Caution
To prevent damage to the seat or seat
cover, care must be taken not to drop
the seat. Do not lean the seat against
the motorcycle or any surface which
may damage the seat or seat cover.
Instead, place the seat, with the seat
cover facing upwards, on a clean, flat
surface which is covered with a soft
cloth.
Do not place any item on the seat
which may cause damage or staining
to the seat cover.
Pillion Seat
1
1. Seat lock
The seat lock is located on the rear
mudguard, below the rear light unit. To
remove the seat, insert the ignition key
into the seat lock and turn it
anticlockwise while pressing down on
the rear of the seat. This will release the
seat from its lock and allow it to be slid
rearwards. If equipped with heated
seats, disconnect the heated seat’s
electrical connector for complete
removal from the motorcycle.

Triumph Tiger XR Specifications

General

Engine Type	Liquid-cooled, 12 valve, DOHC, in-line 3-cylinder
Engine Capacity	800 cc
Torque	79 Nm @ 7, 850 rpm
Transmission	6-speed
Wet Weight	213 kg
Fuel System	Multipoint sequential electronic fuel injection
Power	94 bhp (70 kW) @ 9, 250 rpm
Fuel Tank Capacity	5.0 gallons (19 liters)
Front Suspension	Showa 43mm upside down forks
Rear Suspension	Showa monoshock with hydraulically adjustable preload
Rear Brakes	Single 255mm disc, Nissin single piston caliper
Front Brakes	Twin 308mm floating discs, Nissin 2-piston calipers