disable the function, the machine will only cut part of the graphics which
is within the working range like Figure 6-7-4.
Fiugre6-7-5 Auto Origin
6.7.2 Common Parameters
On the Common Params Settings page, move cursor to 【 Common
Parameters】and press【Enter】. Press【↑】【↓】to move cursor and
press【Z↑】【Z↓】to modify parameters, press【Enter】to save settings.
The【Z AutoFocus】function is mainly used to control the distance between
the laser head and the work table. If the Z axis is used as the lifting shaft
To Next Page
Loading...
Need help?
General
