42
CENTRE THE RUNNING BELT
ILLUSTRATION A
Place treadmill on a level surface. Run Treadmill at
approximately 6-8 km/h to check the running condition.
If the belt has drifted to the right, turn the right adjusting
bolt 1/4 turn clockwise, then start running until centering
the belt.
ILLUSTRATION B
If the belt has drifted to the left, turn the left adjusting
bolt 1/4 turn clockwise, then start running until centering
the belt.
ILLUSTRATION C
Periodically adjust the tightness of the belt as the belt
tends to loosen after use. Turn the left and
right adjusting bolt 1/4 turn clockwise, then re-start
running.
Turn the bolt until the belt is tight.
#20M03T020 ELITE 2000 Treadmill UM.indd 42 2020/04/07 10:05 AM
To Next Page
Loading...
