11
ASSEMBLY STEPS
1. PREPARATION
• Before assembling make sure that you will have enough space around the item.
• Use the supplied parts and hardware for the assembly.
• Before assembling please check whether all the required parts have been supplied as per the exploded drawing on
the opposite page.
• Notice: Some of the smaller parts may be pre-tted to larger components, please ensure you check carefully before
contacting us regarding any missing parts.
STEP 1:
Remove the Weight Guide Tubes (3) from the carton and
insert these into the Rear Base Frame (1) and secure
Bolts (72) from underneath.
Attach the Front Base Frame (2) to the Rear Base Frame
(1) by using 2 Hex Bolts (58), 2 Washers (67) and 2 Nylon
Nuts (70).
Ensure all bolts are tight before proceeding.
STEP 2:
Slide 2 Rubber Rings (25) onto the Weight Guide
Tubes (3). Once completed you can now slide 9 Weight
Plates (16) down the Weight Guide Tubes (3).
Now slide the Selector Shaft (5) down the middle hole in
the weight plates ensuring that the selector shaft’s holes
with the tapered edge face backwards. Line up with the
weight selection holes underneath each weight plate.
You can now slide the Selector Shaft Bushing (44) down
the Selector Shaft (5) ensuring that smaller circle faces
upwards. By simply lifting the Selector Shaft (5) up
slightly you must now slide the Selector Shaft Pin (27)
through the rst hole on the Selector Shaft (5) and the
hole on the Selector Shaft Bushing (44).
Once completed slide the Selector Shaft (5) back down
and slide the Top Weight Plate (15) down the Weight
Guide Tubes (3) and Selector Shaft (5) so that it sits
rmly on top. Now insert the Weight Selector Pin (24)
into any weight for the meantime. Ensure all bolts are
tight before proceeding.
STEP 2
STEP 1
3
1
70
70
2
58
67
67
72
3
16
15
24
27
44
5
25
1
#19M02T008 Power Gym 1.0 UM VERSION 4.indd 11 29/05/2019 13:29
To Next Page
Loading...
