13
If the Water Detector is NOT in original default function (leak sensor), you can change the Assignment into
Leak Sensor as above processes.
Assignment converted into Leak Sensor
The default mode of Water Detector is in Leak Sensor (Leak Detection Mode). You can change the Leak
Detection Mode (Leak Sensor) into Output assigned Mode (Assignment) as below processes. As one Water
Detector can be assigned to only one output on any Control Board, you need to select 24V or 110V and one
of six outputs to be assigned with the Water Detector. When the output has been successfully assigned, the
Water Detector will send alarm message to your Smartphone one minute later when it detects no water on
the reservoirs of the irrigation system.
b. Assignment (Output Assigned Mode)
The default function of Water Detector (WD-1) is to do leak detection and the symbol is a triangle shown in
the Aqua-X Controller. When WD-1 detects water leakage, it will send alarm message to your Smartphone
one minute later. You can also check the alarm message in the Aqua-X Controller.
a. Leak Sensor (Leak Detection Mode)
Blinking
To Next Page
Loading...
