TrolMaster Aqua-X - Page 14

14
or or
Blinking
or
or or or
Aqua-X Controller Water Detector
Each Water Detector can be assigned to a Control Board which has been successfully assigned to the
Aqua-X Controller. The Water Detector can not be assigned to an unassigned Control Board.
One Water Detector can be assigned to onlyone 24V or 110V output. One Aqua-X Controller can connect
up to 30pcs Water Detectors.
If the assigned output of that board is offline, the output symbol will blink on the LCD display of the
Aqua-X Controller.
If the output is successfully assigned with the Water Detector and the Water Detector is connected with
the Aqua-X Controller, there will be a dot displayed before the name of the assigned output on the Control
Board interface as illustrated below.
NOTES:
1.
2.
3.
4.
Control Board Interface