EN 3
vane anemometer BA16
Intended use
Only use the device for measurements of air velocity, air
temperature and volumetric flow within the measuring range
specified in the technical data. Observe and comply with the
technical data.
To use the device for its intended use, only use accessories and
spare parts which have been approved by Trotec.
Improper use
Do not use the device in potentially explosive atmospheres, for
measurements in liquids or at live parts.
Any unauthorised changes, modifications or alterations to the
device are forbidden.
Personnel qualifications
People who use this device must:
• have read and understood the operating manual, especially
the Safety chapter.
Residual risks
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
Warning of electrical voltage
Work on the electrical components must only be
carried out by an authorised specialist company!
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Warning
The device is not a toy and does not belong in the
hands of children.
Warning
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Caution
Keep a sufficient distance from heat sources.
Note
To prevent damages to the device, do not expose it to
extreme temperatures, extreme humidity or moisture.
Note
Do not use abrasive cleaners or solvents to clean the
device.
Information about the device
Device description
The anemometer BA16 can simultaneously measure the
temperature and air velocity.
Temperature measuring is effected by means of an integrated
thermistor in °C or °F.
The air velocity can be indicated in the following units:
• m/s
• km/h
• ft/min
• mph
• knots
• m
3
/min (CMM)
The sensor is located at a so-called gooseneck probe, with that
it is able to measure even in poorly accessible locations.
Further available for the assessment of the measurements are a
Hold and a Max/Min function.
The display illumination can be switched on as needed.
When not in use, an automatic switch-off saves the battery.
Device depiction
No. Designation
1 Measuring sensor with flexible holder
2 Display
3 Operating elements
4 Battery compartment with cover
To Next Page
Loading...
Need help?
General
