Trotec BM31WP - Connecting the appSensor; Calibrating the sensor; Selecting material

6 EN
material moisture measuring device controlled via smartphone BM31WP
Connecting the appSensor
Info
The app can simultaneously be connected to several
different appSensors or appSensors of the same type
and also record several measurements at the same
time.
Proceed as follows to connect the appSensor to the terminal
device:
ü The Trotec MultiMeasure Mobile app is installed.
ü The Bluetooth function on your terminal device is activated.
1. Start the Trotec MultiMeasure Mobile app on the terminal
device.
2. Briefly actuate the On/ off/ measurementbutton(3) three
times to switch on the appSensor.
ð The LED(2) flashes yellow.
3. Press the SENSORS button(6) on the terminal device.
ð The sensors overview opens.
4. Press the Refresh button(7).
ð If the scanning mode was not active before, the colour
of the Refreshbutton(7) will change from grey to black.
The terminal device now scans the surroundings for all
available appSensors.
5. Press the Connect button(8) to connect the desired sensor
to the terminal device.
ð The LED(2) flashes green.
ð The appSensor is connected to the terminal device and
starts measuring.
ð The on-screen display changes to the continuous
measurement.
Sensors
BC21WP
BA16WP
BM22WP
BM31WP
BP21WP
BA30WP
Sensors MEASUREMEN
TS
Reports
CUSTOMERS SETTINGS
Connect
Active sensors nearby
Available sensors
8
7
6
No. Designation Meaning
6 SENSORS button Opens the sensors overview.
7 Refresh button Refreshes the list of sensors near the
terminal device.
8 Connect button Connects the displayed sensor to the
terminal device.
Calibrating the sensor
After switch-on the sensor needs to be recalibrated to the
respective surrounding conditions of measuring location. This is
an automatic process starting when the sensor is connected to
the app after switch-on.
1. Hold the sensor preferably somewhere near the bottom
and in one hand (corrugated rubber coating).
2. Point the measuring device away from the body and any
objects into clear space.
If the sensor displays incorrect values or you have changed its
position during the measurement, you can manually initiate
another calibration process (see Measurement settings).
Selecting material
Before you carry out a measurement you should select the
material to be measured. To do so, please proceed as follows:
1. Press the Menubutton(11).
ð The context menu opens.
2. Press the Sensor settings button(15).
15
MEASUREMEN
TS
Reports
CUSTOMERS SETTINGSSensors
CM-%
BM31WP
Refresh measured value
54 digits
Building moisture cement
54 digits
M-%
0,43 %
Reset min/ max/ Ø
Disconnect sensor
Sensor settings
Start recording
Calibrate
0,43 %
11
[53 | 55] Ø 54
[0,42 | 0,44] Ø 0,43
[0,42 | 0,44] Ø 0,43
ð The sensor settings menu opens.
Via the menu item Features you can choose from the following:
• Building moisture anhydrite
• Building moisture cement