Trotec BM31WP - Carrying out a measurement; Individual value measurement; Refreshing the measured value

EN 7
material moisture measuring device controlled via smartphone BM31WP
Carrying out a measurement
Put the sensor at a right angle completely on the material to be
measured and observe a minimum distance of 8 to 10cm to
corners.
Info
Please note that the displayed values are merely rough
reference values which cannot replace mandatory
CMmeasurements. Since, particularly in case of
mineral building materials, the measurement results
can be influenced by salinization as well as chemical
additives, the determined values shall only be used as
an indicator of near-surface material moisture, not for
an absolute assessment.
Info
Note that moving from a cold area to a warm area can
lead to condensation forming on the device's circuit
board. This physical and unavoidable effect can falsify
the measurement. In this case, the app will either
display incorrect measured values or none at all. Wait a
few minutes until the device has become adjusted to
the changed conditions before carrying out a
measurement.
Individual value measurement
When the appSensor has been successfully connected to the
terminal device, an individual value measurement is started and
the first determined value will be indicated.
Sensors MEASUREMEN
TS
Reports
CUSTOMERS SETTINGS
Refresh measured value
11
BM31WP
10
9
54 digits
Building moisture cement
M-%
CM-%
54 digits
0,43 %
0,43 %
[0,42 | 0,44] Ø 0,43
[0,42 | 0,44] Ø 0,43
[53 | 55] Ø 54
No. Designation Meaning
9 Numeric value
display
Current value: Indicates the currently
determined value in digits without unit.
Building moisture anhydrite/ cement:
Indicates the minimum, maximum and
average values as well as the current
moisture value in digits without unit
(material selection via sensor settings).
M-%: Indicates the minimum, maximum
and average values as well as the
calculated Mmoisture value.
CM-%: Indicates the minimum,
maximum and average values as well as
the calculated CMmoisture value.
10 Refresh
measured value
button
Performs an individual measurement and
refreshes the displayed values.
11 Menubutton Opens the menu for making settings for
the current measurement.
Refreshing the measured value
Proceed as follows to refresh the measured values in the
individual value measurement mode:
1. Press the Refresh measured value button(10) on the
terminal device.
ð The appSensor determines the current measured value
which is then displayed on the terminal device.
2. You can also press the On/ off/ measurement button(3)
on the appSensor.
ð The appSensor determines the current measured value
which is then displayed on the terminal device.