Trotec BM31WP - Measurement settings; Performing an individual spot measurement without image; Recording measured values

8 EN
material moisture measuring device controlled via smartphone BM31WP
Measurement settings
Proceed as follows to adjust the settings for the measurement:
1. Press the Menubutton(11).
ð The context menu opens.
2. Adjust the settings as required.
12
13
14
15
16
MEASUREMEN
TS
Reports
CUSTOMERS SETTINGSSensors
CM-%
BM31WP
Refresh measured value
54 digits
Building moisture cement
54 digits
M-%
0,43 %
Reset min/ max/ Ø
Disconnect sensor
Sensor settings
Start recording
Calibrate
0,43 %
[53 | 55] Ø 54
[0,42 | 0,44] Ø 0,43
[0,42 | 0,44] Ø 0,43
No. Designation Meaning
12 Calibratebutton Calibrates the connected appSensor.
13 Reset min/ max/ Ø
button
Deletes the determined values.
14 Disconnect sensor
button
Disconnects the connected
appSensor from the terminal device.
15 Sensor settings
button
Opens the settings menu for the
connected appSensor.
16 Start recording
button
Starts a recording of the determined
measured values for later evaluation.
Recording measured values
Proceed as follows to record measured values for later
evaluation:
1. Press the Menubutton(11).
ð The context menu opens.
2. Press the Start recording button(16).
ð A menu listing different measurement methods will be
displayed:
• Individual spot measurement without image
• Individual spot measurement with image
• Matrix measurement without background image
• Matrix measurement with background image
If you select one of the measurement methods, you will be
redirected to the respective submenu and the RECbutton(17)
will displayed instead of the Menubutton(11).
Performing an individual spot measurement without image
The individual spot measurement without image allows you to
record several individual measuring points. To do so, please
proceed as follows:
1. Repeatedly press the On/ off/ measurement button(3) on
the appSensor or the Refresh measured value button(10)
on the terminal device until you have logged all the
required measured values.
Sensors MEASUREMEN
TS
Reports
CUSTOMERS SETTINGS
Refresh measured value
17
BM31WP
10
9
Building moisture cement
M-%
CM-%
54 digits
0,43 %
0,43 %
9,1
25
18
[53 | 55] Ø 54
[0,42 | 0,44] Ø 0,43
[0,42 | 0,44] Ø 0,43
No. Designation Meaning
9 Numeric value
display
Building moisture anhydrite/
cement: Indicates the minimum,
maximum and average values as well
as the current moisture value in digits
without unit (material selection via
sensor settings).
M-%: Indicates the minimum,
maximum and average values as well
as the calculated Mmoisture value.
CM-%: Indicates the minimum,
maximum and average values as well
as the calculated CMmoisture value.
10 Refresh measured
value button
Performs an individual measurement
and refreshes the displayed values.
17 RECbutton Opens the context menu for sensors.
18 Measurement
series indication
Measured values: Indicates the
measured values of the measurement
series in digits without unit.