Trotec BM31WP - Performing an individual spot measurement with image

EN 9
material moisture measuring device controlled via smartphone BM31WP
Performing an individual spot measurement with image
If you have selected individual spot measurement with image,
you will be prompted to choose whether you want to use a
photo already saved in the mobile device's gallery or take a new
one directly in the app. Choose an image section that best
matches the measuring surface.
For measured value data logging please proceed as follows:
1. Tap the screen at the exact measuring location. The
measured value will be displayed at this location.
2. You can also press the On/ off/ measurement button(3)
on the appSensor.
ð The measured value will be displayed in a specified grid
on the background image. Pressing the Shift measuring
point button(20) allows you to adjust the position of the
measuring points. By pressing the Shift measuring point
button(20) once more you can return to the measuring
mode.
17
9
19
Sensors MEASUREMEN
TS
Reports
CUSTOMERS SETTINGS
BM31WP
Building moisture cement
M-%
CM-%
54 digits
0,43 %
0,43 %
Measured value for 1.3
Undo
20
9,1
9,7
9,1
[53 | 55] Ø 54
[0,42 | 0,44] Ø 0,43
[0,42 | 0,44] Ø 0,43
No. Designation Meaning
9 Numeric value
display
Building moisture anhydrite/
cement: Indicates the minimum,
maximum and average values as well
as the current moisture value in digits
without unit (material selection via
sensor settings).
M-%: Indicates the minimum,
maximum and average values as well
as the calculated Mmoisture value.
CM-%: Indicates the minimum,
maximum and average values as well
as the calculated CMmoisture value.
No. Designation Meaning
17 RECbutton Opens the context menu for sensors.
19 Measuring field
indication
Indicates the image of the measuring
field and the values measured at the
measuring points.
20 Shift measuring
point button
Stops the measured value data
logging and allows you to relocate the
measuring points on the background
image.