3 EN
Operating manual – local air conditioner PAC 3500 E
Residual risks
Hazardous electric current!
Work on the electrical components must only be
carried out by an electrically skilled person or an
authorised specialist company.
Hazardous electric current!
Before any work on the device, remove the mains plug
from the mains socket!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Danger!
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Danger!
The device is not a toy and does not belong in the
hands of children.
Danger!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Caution!
Do not operate the device without an inserted air filter!
Without air filter the inside of the device will be heavily
contaminated, this could reduce the dehumidification
performance and result in damage to the device.
Behaviour in the event of an emergency
1. In an emergency, disconnect the device from the mains
feed-in: Switch the device off and disconnect the power
cable from the mains socket. Hold onto the mains plug
while doing so.
2. Do not reconnect a defective device to the mains.
Information about the device
Device description
The device serves the purpose of cooling the room air. It further
filters and dehumidifies the air thus creating an agreeable room
climate.
In ventilation mode the device also provides the opportunity of
air circulation without cooling effect.
In dehumidification mode moisture is withdrawn from the air.
The device operates fully automatically and features a variety of
further options, the device can, for instance, be switched on or
off automatically with time delay via the timer function.
Handling the device can be accomplished via the control panel
at the device or the supplied infrared remote control.
The device was designed for universal and flexible application.
Due to its compact dimensions it can be easily transported and
used in all interior spaces.
The unit cools the room air by withdrawing warmth. The
absorbed warmth is emitted to the outside via the exhaust air
hose, cooled air is fed to the installation site by means of a fan.
Accumulating condensate trickles from the evaporator onto the
hot condenser, there it evaporates and then is transported to the
outside via the exhaust air hose.
To Next Page
Loading...
