Trotec PAC 3500 E - Transport and Storage Procedures; Transporting the Device

EN 4
Operating manual – local air conditioner PAC 3500 E
Device depiction
1
2
3
8
4
5
6
2
7
13
14
6
16
12
15
15
9
11
10
No. Designation
1 Air outlet with ventilation flaps
2 Wheels
3 Compartment for remote control
4 Air inlet with EVA air filter
5 Hose connector with sealing cap and rubber stopper
6 Air inlet with CON air filter
7 CON air filter
8 Flat nozzle
9 Remote control
10 Exhaust air hose
11 EVA air filter
12 Condensate outlet with sealing cap and rubber stopper
13 Exhaust air hose connection
14 Power cable holder
15 Handle
16 Control panel with remote control receiver
Transport and storage
Transport
Before transporting the device, proceed as follows:
• Switch off the device.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
• To make the device easier to transport, it is fitted with
wheels.
• Do not use the power cable to drag the device.
• Only wheel the device on a level and smooth surface.
After transporting the device, observe the following:
• Set up the device in an upright position after transport.
• Leave the device to rest for 12-24hours, so the
refrigerant can accumulate within the compressor. Wait
12-24hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.