EN 10
Operating manual – air cooler PAE 25
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
• Switch off the device.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Empty and clean the water tank (see chapter
Maintenance).
• Clean the device according to the Maintenance chapter.
• Store the device according to the Storage chapter.
Available accessories
Evaporation filter PAE 25
Article number: 7.710.000.837
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
• Check the power connection.
• Check the power cable and mains plug for damages.
• Check the on-site fusing.
• Wait for 10minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device works with reduced or no capacity
• Check the position of the ventilation flaps. They should be
opened to the maximum.
• Check the air filter(s) for dirt. If necessary, clean or replace
the air filter(s).
• Check the minimum distance to walls or other objects.
Position the device a little more in the room's centre, if
required.
The device is running, but there is no air cooling or pump
operation
• Check whether air cooling mode is activated. The air
cooling symbol(19) should be illuminated.
• Check the filling level of the water tank (see chapter Filling
the water tank). The air cooling symbol(19) should not
flash.
• Check whether there are any objects blocking the pump
inlet. The pump inlet should not be blocked.
• In case the pump does not operate despite a correctly filled
water tank and activated air cooling mode, the pump might
be defective. Please contact the customer service.
Water leaks
• Check the device for leaks.
• Check the water tank for tight fit.
To Next Page
Loading...
Need help?
General
