Trotec PAE 49 - Filter Installation and Maintenance; Installing Evaporation and Air Filters

10 EN
air cooler PAE 49 / PAE 50
Inserting evaporation filter and air filter
Note
When set to air cooling mode, the device should not be
operated without the evaporation filter, otherwise
cooling will not work.
Note
Do not operate the device without an air filter inserted
into the air inlet!
Without the air filter, the inside of the device will be
heavily contaminated. This could reduce the
performance and result in damage to the device.
• Make sure that both the evaporation and the air filter are
installed before switching the device on.
Adjusting the ventilation flaps
• Prior to switching the device on, adjust the ventilation flaps
at the air outlet.
Scent option
Additionally, the device offers the possibility to distribute a scent
during operation.
Note
Put scented oil into the designated scented oil
tank(17) only.
Use standard scented oil. Proceed as follows to use the scent
option:
ü The device is switched off and the power cable is
disconnected from the mains.
1. Slide the scented oil tank out of the holder and put 2 to
3 drops of scented oil into the scented oil tank.
17
2. Push the scented oil tankback into the holder.
3. Attach the scented oil tank(17) to the device.