Trotec TA400 User Manual

EN 10
Operating manual – dynamic pressure anemometer TA400
Deleting saved measurements
There are two ways to delete measured values:
• Deleting all saved measurements
• Deleting a certain measured value
To delete all saved entries, please proceed as follows:
1. Press the Setup button(14) for approx. 2s.
ð The setup menu will be opened.
2. Repeatedly press the Unit
(7) or Unit button(13)
until ALL is displayed.
ð At the same time the clear memory indication(24)
appears in the bottom right corner.
3. Press the REC/AVGbutton(6) to confirm the selection.
ð The measuring modes are indicated in the measuring
mode display(35).
ð YES will be indicated in the temperature/time
display(16).
4. Press the Unit
(7) or Unit button(13) to choose
whether to delete the memory (yes) or not (no).
5. Press the REC/AVGbutton to confirm the selection.
6. Press the Setup button(14) for approx. 2s to exit the
settings menu.
To delete one specific measured value, please proceed as
follows:
1. Press the REC/AVG button(6) for approx. 2s.
ð REC will be displayed in the temperature/time
indication(16).
2. Press the Unit
(7) or Unit button(13) to choose the
desired memory location.
ð The saved measured value is displayed in the
measurement value display(19).
3. Press the SAVE/CLEAR button(8).
ð The selected measurement will be deleted.
ð An acoustic confirmation signal will be emitted.
ð The next saved measurement will be displayed.
4. Press the REC/AVG button(6) for approx. 2s to return to the
measuring mode.
Setting the automatic switch-off
With activated automatic switch-off function the device
switches off automatically after approx. 5minutes of non-use.
1. Press the Setup button(14) for approx. 2s.
ð The setup menu will be opened.
2. Repeatedly press the Unit
(7) or Unit button(13)
until SLEEP is displayed.
3. Press the REC/AVGbutton(6) to confirm the selection.
ð On or off (activated or deactivated automatic switch-off)
will be indicated in the temperature/time display(16).
4. Press the Unit
(7) or Unit button(13) to choose the
desired setting.
5. Press the REC/AVGbutton(6) to confirm the selection.
6. Press the Setup button(14) for approx. 2s to exit the
settings menu.
Setting the background illumination
The display comes with a background illumination that can be
switched on as needed.
1. Press the Setup / illumination button(14) to switch the
background illumination on or off.
Switching the device off
1. Press the power button(10).
ð The device is switched off.

Trotec TA400 Specifications

General

Brand	Trotec
Model	TA400
Category	Measuring Instruments
Language	English