5 EN
Operating manual – dynamic pressure anemometer TA400
Scope of delivery
• 1 x Dynamic pressure anemometer TA400
• 1x 9V battery
• 1 x Pitot tube
• 1 x Tube, white
• 1 x Tube, black
• 1 x Transport case
• 1 x Mini USB cable
• 1 x CD-ROM with Manometer&Flowmeter software
• 1 x Getting started guide
Transport and storage
Transport
For transporting the device, use the transport case included in
the scope of delivery in order to protect the device from external
influences.
Before transporting the device, please observe the following:
• Remove the hoses from the connections at device and
Pitot tube.
Storage
Remove the hoses from the connections at device and Pitot tube
prior to storage.
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat.
• protected from dust and direct sunlight.
• use the transport case to protect it from invasive dust.
• The storage temperature is the same as the range given in
the Technical data chapter.
• Remove the batteries from the device.
Operation
Inserting the battery
Caution!
Make sure that the surface of the device is dry and the
device is switched off.
1. Open the battery compartment at the rear of the device by
sliding the cover down at the arrow mark.
2. Use the battery clip to connect the 9V battery with correct
polarity.
3. Place the battery with the battery clip into the battery
compartment.
4. Slide the cover back onto the battery compartment.
ð The cover should click into place.
Switching the device on
Note:
Note that moving from a cold area to a warm area can lead to
condensation forming on the device's circuit board. This
physical and unavoidable effect can falsify the measurement. In
this case, the display shows either no measured values or they
are incorrect. Wait a few minutes until the device has become
adjusted to the changed conditions before carrying out a
measurement.
1. Press the power button(10).
ð The device is switched on.
To Next Page
Loading...
Need help?
General
