Trotec TTK 28 E - Assembly and Installation; Unpacking and Setup

EN 6
Operating manual – dehumidifier TTK 28 E
Assembly and installation
Scope of delivery
• 1x device
• 1x condensation drain hose, length: 0.6 m,
diameter: 14 mm
• 2x air filter
• 4x wheel
• 4x axle
• 1x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Mounting the wheels
1. Insert an axle into a wheel.
Repeat this step for the 3remaining wheels.
2. Tilt the device. Put a wheel into the mounts at the bottom of
the device until it locks in place.
Repeat this step for the 3remaining wheels.
3. After mounting the wheels, place the device in an upright
position.
4. Leave the device to rest for 12-24hours, so the refrigerant
can accumulate within the compressor. Wait 12-24hours
before switching the device back on! Acting contrary might
lead to compressor damage and a malfunctioning device. If
so, any warranty claims will be voided.