Trotec TTK 30 E - Operating Modes Explained; Dehumidification and Automatic Modes; Other Operation Modes

7 EN
Operating manual – dehumidifier TTK 30 E
Dehumidification
The device keeps running until reaching the preselected relative
room humidity. Then the compressor switches off and the fan
keeps running. Once the preselected relative room humidity is
exceeded, the compressor switches back on.
The relative room humidity can be set within a setting range
from 30 % to 80 % in steps of 5%. Additionally, the CO setting
for permanent dehumidification (continuous operation) can be
selected.
You can choose between low and high fan speed.
1. Press the MODE button(14).
ð The indication of the currently selected operating mode
flashes.
2. Press the arrow buttons (18, 19) until the LED for
dehumidification mode(13) starts flashing.
3. Then press the MODE button(14) again.
ð Dehumidification mode is selected.
4. Press the arrow buttons(18, 19) to adjust the relative room
humidity or to select continuous operation (CO).
5. Press the FAN button(17) to select either low or high fan
speed.
ð The selected fan speed is indicated on the fan speed
indication(21).
Automatic operation
The relative room humidity is preset to 55 % and cannot be
changed.
If the relative room humidity lies between 55 % and 70 %, the
fan automatically switches over to low speed.
Below a relative room humidity of 55%, the compressor
switches off.
Above a relative room humidity of 70 %, the fan runs at the
highest level.
Info
In automatic mode, the fan speed indication(21) does
not change automatically.
1. Press the MODE button(14).
ð The indication of the currently selected operating mode
flashes.
2. Press the arrow buttons (18, 19) until the LED for
automatic mode(13) starts flashing.
3. Then press the MODE button(14) again.
ð Automatic mode is selected.
Continuous operation
The device dehumidifies the air constantly and regardless of the
relative room humidity.
The relative room humidity and the fan speed cannot be set in
this operating mode.
1. Press the MODE button(14).
ð The indication of the currently selected operating mode
flashes.
2. Press the arrow buttons (18, 19) until the LED for
continuous operation(13) starts flashing.
3. Then press the MODE button(14) again.
ð Continuous operation is selected.
Laundry drying function
The device may be used to dry clothes in a more timely manner.
When positioning the device or a clothes horse, please observe
the minimum distances specified in the technical data.
The device dehumidifies the air constantly and regardless of the
relative room humidity. The fan runs at the highest speed.
The relative room humidity and the fan speed cannot be set in
this operating mode.
1. Press the MODE button(14).
ð The indication of the currently selected operating mode
flashes.
2. Press the arrow buttons (18, 19) until the LED for the
laundry drying function(13) starts flashing.
3. Then press the MODE button(14) again.
ð The laundry drying function is selected.
Ventilation
In ventilation mode you can choose between low and high fan
speed.
1. Press the MODE button(14).
ð The indication of the currently selected operating mode
flashes.
2. Press the arrow buttons (18, 19) until the LED for
ventilation mode(13) starts flashing.
3. Then press the MODE button(14) again.
ð Ventilation mode is selected.
4. Press the FAN button(17) to select either low or high fan
speed.
ð The selected fan speed is indicated on the fan speed
indication(21).