Trotec TTK 30 E - Operation and Controls; Operating Elements Overview; Device Activation and Humidity Setting

EN 6
Operating manual – dehumidifier TTK 30 E
Operation
Notes:
• Avoid open doors and windows.
• After being switched on, the device operates fully
automatically.
• The fan permanently runs in dehumidification mode even
after the set nominal value has been reached until the
device is switched off.
Operating elements
Timer
Tank Full
Defrost Continuous
Automatic
Fast Dry Clothes
Dehumidify
Fan
FAN
TIMER
MODE
ON/OFF
11 12 13
14151617
23
22
20
21
19 18
No. Designation Meaning
11 Timer indication Illuminated when the timer is
programmed
12 Segment display Indicates the relative room
humidity level
Indicates the desired relative
room humidity during setting
Indicates continuous operation
CO in dehumidification mode
Indicates the number of hours
during timer programming
13 Operating modes
indication
Indication of active operating
mode:
Dehumidify = Dehumidification
Automatic = Automatic mode
Continuous = Continuous
operation
Fast Dry Clothes = Laundry
drying function
Fan =Ventilation
No. Designation Meaning
14 MODE button Selection button for operating
modes:
Dehumidification
Automatic operation
Continuous operation
Laundry drying function
Ventilation
15 ON/OFF button Power button:
Switches the device on or off
16 TIMER button Starts programming for the timer
function
17 FAN button Setting the fan speed in
dehumidification and ventilation
mode:
= low
= high
18 Arrow buttons Setting the operating mode
Setting the relative room humidity
Setting the number of hours for
the timer function
19
20 Child lock indication Illuminated when the child lock is
active
21 Fan speed indication Indication of the fan speed:
= low
= high
22 Defrost indication Illuminated when automatic
defrosting is in progress
23 Tank Full indication Illuminated when the
condensation tank is full
Switching the device on
Once you have completely installed the device as described in
the Start-up chapter, you can switch it on.
1. Press the ON/OFF button(15).
ð The device starts in automatic mode.
Setting the operating mode
Setting the relative room humidity
You can only change the relative room humidity in
dehumidification mode.
1. Press the arrow buttons(18, 19) to adjust the relative room
humidity. Setting is possible in the range between 30 %
and 80 % in steps of 5%.
ð The desired relative room humidity is indicated in the
segment display(12) for approx.5seconds. Then the
current relative room humidity is displayed again.