Trotec TTK 96 E - Condensation Tank Maintenance; Emptying the Condensation Tank

16 EN
dehumidifier TTK 96 E / TTK 127 E
2. Clean the filter using a slightly damp, soft, lint-free cloth.
If the filter is heavily contaminated, clean it with warm
water mixed with a neutral cleaning agent.
3. Allow the filter to dry completely. Do not insert a wet filter
into the device!
4. Reinsert the air filter into the device.
5. Press the FILTER button(26) to carry out a filter reset. This
is only possible when the Filter LED(13) was previously
illuminated. After the reset the LED goes out.
Emptying the condensation tank
If the condensation tank is full or not inserted correctly, the
Full LED(17) lights up and the messageP2 appears on the
segment display(20). The compressor and fan will switch off.
1. Take the condensation tank out of the device.
2. Empty the condensation tank over a drain or sink.
3. Rinse the tank with clear water. Clean the tank regularly
using a mild cleaning agent (no detergent!).