Trotec TTK 96 E - Device Operation Controls; General Operation Guidelines; Switching the Device On; Setting the Operating Mode

EN 9
dehumidifier TTK 96 E / TTK 127 E
5. Check the holder for tight fit.
ð If needed, you may now wind the power cable around
the holder.
Inserting the condensation tank
• Ensure that the float inside the condensation tank is
inserted correctly.
• Ensure that the condensation tank is empty and inserted
correctly.
Connecting the power cable
• Insert the mains plug into a properly secured mains
socket.
Operation
• Avoid open doors and windows.
• After being switched on, the device operates fully
automatically.
• The fan permanently runs in dehumidification mode even
after the set nominal value has been reached until the
device is switched off.
Operating elements
13 14 17 18 19 20
2223242526
15 16
27 21
12
No. Designation Meaning
12 COMFORT LED Comfort mode active
13 FILTER LED Filter needs to be cleaned
14 Auto defrost LED Automatic defrosting active
15 CONT. LED Continuous operation mode active
16 TURBO LED Fan runs at stage2 (high fan speed)
17 FullLED Condensation tank full or not inserted
correctly
18 Off LED Timer for automatic switch-off active
19 On LED Timer for automatic switch-on active
No. Designation Meaning
20 Segment display Indication of the current relative room
humidity level
Indication of the relative room humidity
level during set-up
Indication of the number of hours during
timer programming
Indication of error codes
21 POWER button Power button:
Switching the device on or off
22 Selection button ◄= Decrease value
►= Increase value
For the humidity level:
35% to 85% in increments of 5%
For the timer function:
0 to 10h in increments of 0.5h
10 to 24h in increments of 1h
23 TIMER button Switches the timer function on or off.
24 TURBO button Sets the fan speed:
Stage1= normal
Stage2= high (laundry drying function)
25 CONT. button Switches continuous operation on or off.
26 FILTER button Resets the cleaning cycle for the filter.
27 COMFORT button Switches comfort mode on or off.
Switching the device on
Once you have completely installed the device as described in
the chapter Assembly and start-up, you can switch it on.
1. Press the POWER button(21).
ð The device starts to dehumidify.
Setting the operating mode
• Dehumidification
• Continuous operation
• Comfort mode
• Laundry drying function
Dehumidification
The device keeps running until reaching the desired relative
room humidity. Then the compressor switches off, but the fan
keeps running. Once the desired relative room humidity is
exceeded, the compressor switches back on.
In this operating mode, the desired relative room humidity can
be set at any time in increments of 5% within a setting range of
35% to 85%.