Troy-Bilt 208cc FLEX User Manual

Controls & Features
4
12
Attachment Control Safety Lock
Kickstand
Cold Weather/Warm
Weather Control
Handle Adjustment Knob
On/Off Switch
Attachment Control Lever
Drive Control Lever
Fuel Cap
Oil Fill Cap
Recoil Starter
Choke
Key
Primer
Figure 4-1
Attachment Control Lever
The attachment control lever is for deploying power to the
various available attachments. See also Figure 4-2.
Handle Adjustment Knobs
Utilize these two knobs to adjust the height and position of the
FLEX™ Power Base’s handle assembly. Refer to Installing and
Adjusting the Handle in the Assembly and Setup Section of this
manual for specific instructions regarding adjusting the handle.
Cold Weather/Warm Weather Control
This control is utilized throughout the year. Turn the control to
Winter for Winter operation (below 32F, and Summer (above
32F for Summer operation.
Kickstand
The kickstand is utilized to hold the FLEX™ Power Base in an
upright and parked position when there is NO attachment
present. It also locks the attachment to the power base (when in
“Up” position) and unlocks the attachment when placed in the
down position.
Recoil Starter
The recoil starter employs a starter rope and handle used to pull-
start the engine.

Troy-Bilt 208cc FLEX Specifications

General

Engine Displacement	208cc
Fuel Type	Gasoline
Starting System	Recoil
Outlets	120V 20A Outlets
Engine Type	4-Cycle OHV
Noise Level	68 dBA