ASSEMBLY
Your generator requires some assembHyand is ready for
use after it has been properHy serviced with the
recommended o[Hand fuel
ff you have any quesqons with the assembHyof your
generator, pHeasecaHHthe generator heHpH[neat
1-888-6 m1-6708. If caHH[ngfor ass[stance_pHeasehave the
model revision_ and seriaHnumber from the data tag available.
See "KnowYour Generator" for data tag Hocation.
Unpackin8 the Generator
H. Set the carton on a rigid fiat surface,
2. Remove everything from carton except generator.
3. Open carton compHeteHyby cutting each corner from
top to bottom.
4. Leave generator on carton to install wheeH kit.
install Wheel Kit
NOTE: VVheeH kit is not intended for over-the-road use.
You wiHHneed the following tooHs to install these
components:
° [/2" or [3mm wrench
o Socket wrench with a [/2" or [3mm socket
o PHiers
° Safety gHasses
Refer to Figure [ and install the wheel [(it as follows:
H. Tip generator so that engine end is up.
Z SHideaxHethrough both mounting brackets,
3. PHacea wheeH on each side as shown in Figure HA.
4. PHacea washer on axHeand then pilate an eoring in axle
groove.
Axle
Wheel
FHatVVasher
Support Leg jj
Cap Screw Axle /
/
/ /
WheeH EoRing
- Hex Nut
0
To Next Page
Loading...
