Troy-Bilt CS4265 User Manual

Operator's Manual
Chipper / Shredder
Models CS4210
CS4265
Model CS4210 Shown
IMPORTANT: Read safety rules and instructions carefully before operating equipment.
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-
covered or grass-covered land unless the enginds exhaust system is equipped with a spark arrester meeting applicable local or state laws (if
any). If a spark arrester is used, it should be maintained in effective working order by the operator. Inthe State of California the above is required
by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark
arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 36113!
Cleveland, Ohio 44136-0019.
TROY-BILTLLC.P.O.BOX361131,CLEVELAND,OHIO44136-0019
PRINTED IN U.S.A. FORM NO. 769-00830A
(4/15/04)

Troy-Bilt CS4265 Specifications

General

Reduction Ratio	10:1
Start Type	Recoil
Wheel Type	Pneumatic
Engine Type	4-Cycle
Engine	Briggs & Stratton
Chipping Capacity	3 in.
Shredder Hammer Speed	3600 RPM
Wheel Size	10 in

Summary

Finding Model Number

Customer Support

Important Safe Operation Practices

Training

Read and follow all instructions, be familiar with controls, and ensure proper operation before use.

Preparation

Inspect the area, wear safety gear, check fasteners, and handle fuel with extreme care.

Operation

Maintenance and Storage

Safety Labels

Assembling Your Chipper Shredder

Lowering the Chipper Chute

Pivot the chipper chute downward until it clicks into the lock rod for proper operation.

Know Your Chipper Shredder

Key Component Descriptions

Details on engine controls, starter, hopper, chutes, and handles for identification.

Assembly Instructions

Guides for attaching the debris collection bag and the tow bar.

Operating Your Chipper Shredder

Gas and Oil Fill-Up

Service the engine with gasoline and oil as instructed in the separate engine manual.

Starting Engine

Attach spark plug wire, ensure choke is set, move throttle, and pull starter handle.

Stopping Engine

Shredding Operation

Chipping Operation

Clearing a Clogged Hopper

Maintaining Your Chipper Shredder

Lubrication

Lubricate the spring latch, chipper chute hinge, and chute deflector pivot points.

Maintenance Safety Precautions

Always stop engine, disconnect spark plug, and ground it before performing maintenance.

Engine Maintenance

Chipper Shredder Maintenance

Cleaning the Reduction Chamber

Replacing the Chipper Blades

Replacing the Shredder Blade

Troubleshooting

Parts List

Manufacturer's Limited Warranty