Troy-Bilt Storm 7524 User Manual

Storm
Snow Thrower
Models
7524 & 8526
PRINTED IN U.S.A.
Operator’s Manual
FORM NO .
769-00394B.fm
(6/2003)
IMPORTANT: Read safety rules and instructions carefully before operating equipment.
TROY-BILT LLC. P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized
service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.

Troy-Bilt Storm 7524 Specifications

General

Engine Type	4-Cycle
Engine	Troy-Bilt
Auger Material	Steel
Auger Gear Case	Aluminum
Drive System	Self-Propelled
Number of Forward Speeds	6
Number of Reverse Speeds	2
Electric Start	Yes
Clearing Width	24 inches
Intake Height	21 inches
Auger Diameter	12 inches
Impeller Diameter	12 inches
Speeds	6
Starting System	Electric Start

Summary

Important Safe Operation Practices

Training Safety

Read, understand, and follow all instructions on the machine and in the manual before operating.

Preparation Safety

Inspect area, wear safety gear, proper clothing, use grounded cords, disengage clutches.

Operation Safety

Avoid rotating parts, ensure clutch levers operate correctly, use safety devices.

Maintenance & Storage

Maintenance Preparation

Disengage clutches, stop engine, disconnect spark plug wire before cleaning or repairing.

Assembling Your Snow Thrower

Final Adjustments and Checks

Adjust tire pressure, traction control, and auger control before first use for safety and performance.

Know Your Snow Thrower

Primary Controls Overview

Familiarize yourself with traction control, shift lever, auger control, and safety key.

Operating Your Snow Thrower

Engine Starting and Stopping

Procedures for starting the engine using electric or recoil starter, and safely stopping it.

Engaging Drive and Auger

How to engage wheel drive and augers for snow throwing.

Making Adjustments

Shift Rod Adjustment

Traction Control Adjustment

Maintaining Your Snow Thrower

Lubrication Points

Lubricate drive/shifting mechanism, gear shaft, gear case, auger shaft, bearings, discharge chute, and control cams.

Servicing Your Snow Thrower

Auger Servicing

Belt Replacement

Troubleshooting